-
Hallo Sir !
How would I read RSSI, is it already been implemented ?
Is the channelspacing within the defined rx bandwith, or are these two different settings ?
I am planning to create a small r…
-
Whenever I try to use anything (except for AM) on a frequency such as 433MHz, it'll run for about 5 seconds then stop with no rhyme or reason. It just doesn't work at all on 27MHz, and flat-out crashe…
-
Hi,
First of all great plugin in. I really like it in combination to add my 433MHz devices to the automation world.
Regarding the possible "types" I only miss the generic "socket". Is it possible …
-
I see the BOM for the [FlockOne](http://github.com/RavenLRS/Flock/tree/master/hardware/FlockOne) uses a 433MHz chip, are there plans for using other bands, such as 915MHz? I think 915MHz is more popul…
-
I am running SimpleRCScanner on a NodeMCU.
After adding:
```
#if defined(ESP8266) || defined(ESP32)
// interrupt handler and related code must be in RAM on ESP8266,
#define RECEIVE_ATTR I…
-
### The problem
First off, thank you @deviantintegral for carrying the torch for this add-on. I haven't had the time to maintain it, and I recently disconnected the SDR from my Home Assistant box (af…
-
Add Secrets on all codes
- [x] ESP-NOW Gateway
- [x] HA_BME280_Sensor_MQTT
- [ ] 433mHz
- [x] Greta light still to go (Not done but not needed since now using ESPHOME.
-
- Create a snapshot of person that rings
- last picture to be available on http server
- support for wireless doorbells on 433Mhz (like Silvercrest )
- to be able to configure wifi as AP or via ser…
-
I tested FT8 and it works. However, there have been some issues where a wider pulse appears every time the symbol switches, which can contaminate the spectrum. And only after clicking "open" to open t…
-
Setup:
Node A: rc-switch sender
https://pastebin.com/dajLZSe3
Node B: rc-switch receiver
https://pastebin.com/RG29GGrs
My Problem is that the sending Node A sends the message **22 times** (…