-
### Description
Bed leveling isn't activating at all during prints on the last 1.3.5 firmware. It was working fine on older 1.2.2.
### Steps to Reproduce
1. Do a bed mesh and use I M420 S…
-
Does this plug-in support Makergear M3-ID (dual extruder) with Marlin 1.1.6.1.1? The M3-ID printer comes equipped with the BLTouch probe with firmware support included.
I have the plug-installed a…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When using MKS_UI (TFT_LVGL_UI) there are Y axis motion losses / offsets at random Z heights,…
phcay updated
3 months ago
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
In certain circonstances, the printing head crashes after a Bed Leveling followed by a Store …
-
### Did you test the latest `extui` code or prerelease?
Yes, and the problem still exists.
### Bug Description
Reproduction steps:
**Running CR6-SE 6.1 on BTT board , with neopixel attache…
-
Cannot get the TFT35 touchscreen to work with octoprint using a MKS GEN L?
When removing the touchscreen, octoprint works normally.
How to fix this problem
-
I made a post in the main branch of [Marlin](https://github.com/MarlinFirmware/Marlin/issues/22996) & another user [here](https://github.com/bigtreetech/SKR-2/issues/96) has a similar issue.
What I…
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…