-
Hey all. I want to preface this by saying that I have no experience with hal programming, and have only recently started to study the workings of this crate. I would however like to learn, and possibl…
-
### Describe the issue
A bit of backstory first: I wanted to update my drone from BF 4.3 RC4 to the release 4.3 and while setting it up I wanted to test failsafe by arming and turning my radio off bu…
-
@conuthead
settings: proshot1000 4KHz update.
yellow: proshot input signal
light blue: function "transferComplete" begin 1–>0, end 0->1
dark blue: motor phaseA
there is 50% input data lo…
-
Yesterday I was testing out Butterflight 3.6. Since I have a heavy freestyle quad with a lot of mass on the pitch axis I usually need a bit of anti-gravity. So after updating I set AG to 2. Did a test…
-
### Describe the bug
Calib arm flag not cleared when reflashing from configurator - no output observed from gyro
### To Reproduce
Reflash 4.4.0+ from configurator
Load custom defaults for …
-
updated one of my quad Fury F3S FC with Spedix GS35A 4in1 ESC from BuF 3.4.2 to BuF 3.5.0 and now only motors 2 and 4 are spinning. plugged it to BLHeli 32 Configurator and it only see ESC 2 and 4. re…
-
Has anyone found or made a simple version of BLheli that can be compiled to just run a brushless motor forward/reverse? I was thinking something like a DSHOT setup that takes no calibration and simpl…
-
### Describe the bug
We purchased three Pixhawk 6x Rev 8 with Standard Baseboard V1. The first autopilot already had the PX4 v1.14.2 dev firmware and the second autopilot already had the PX4 v1.15.0 …
-
I did the initial flash and one of my ESC's disappeared from JESC and BLHeliSuite16714902. All four used to show up in both tools. The solder connections are very clean and I checked all with a volt…
-
ESC's are not functioning properly, random 100% errors on the telemetry info in BTFL 4.4.0 when rebooting. So for example first 100% loss on motor 2 and with the next reboot on motor 4 completely rand…