-
I installed MoonCord 0.3.1 on my Fluiddpi which uses the most current Klipper, Moonraker and OS files.
As I just got the update notification for 0.4.0, I updated via the Fluidd-UI. During the updat…
-
I installed Klipperscreen and got the UI to appear on my touchscreen but it will not connect to my ender 3. I ran journalctl -xe -u KlipperScreen | cat and got this.
● KlipperScreen.service - Kl…
-
My screen stays on indefinitely, regardless of timeout setting. I've attached my log file, see below. Timeout is currently set to 5 minutes.
[KlipperScreen.log](https://github.com/jordanruthe/Klipp…
-
### What happened
When the keepalive function is run, wifi does not reconnect.
### What did you expect to happen
Wifi should reconnect.
### How to reproduce
Not sure this is easily repr…
-
### What happened
After successfully imaging a drive with Fluiddpi and entering the web interface of Fluidd/Mainsail, making sure that everything is up to date (updated using the web controls and KIA…
-
## Affected Version(s):
fluidd. v1.16.2
UP TO DATE
klipper v0.9.1-667-g31761500
UP TO DATE
moonraker. v0.7.1-34-g5522e15
Raspberry Pi Zero W Rev 1.1
--
ARMv6-compatible processor rev …
-
Hi!
Having only used FluiddPi for a only a few prints, I wasn't sure if this issue belongs here or in one of the other components that make up the project. If someone could point me in the right di…
-
## Affected Version(s):
(The versions of fluidd this issue occurs on.)
- klipper version: v0.10.0-167-g2b7d0bba
- moonraker version: v0.7.1-194-geda5623
- fluidd version: v1.16.2
## Platform: R…
-
Is there a way tp Change Fluiddpi to the 24h Format?
-
With BTT PI TFT50 installed the TFT will display and operate but web interface times out. If I unplug tft ribbon cable and reboot pi my web interface can connect. Using Fluidd.
[moonraker_conf.txt](h…