-
Hi,
Is it possible to subscribe to multiple mqtt topics on homebridge-homeqtt-alarm for sensor activity?
I'm aware that this was designed to be used with Sonoff RF bridge so all sensor activity is …
-
Any one have the same issue where the remote will show up when you start homebridge in the control center and in the Home app, but then it disappears?
I had alarm dot com and roku disappearing aft…
-
## Verify the following before opening an trouble issue
**Go over all the following points, and put an `x` in all the boxes that apply.
If you're unsure about any of these, don't hesitate to ask. …
-
Hi,
Not sure if others have this issue, but after a few hours my sensors are switching from open to close continuously at 1 second intervals or they are frozen in a state and are not responding, if…
-
Firstly thanks so much for this plugin, it's great!
I can see that the motion sensors are presented to Homekit through Homebridge along with the door contacts, but whilst the door contacts do reflect…
-
So there is a new project called [pyalarmcom](https://github.com/schwark/pyalarmcom) that provides a command line interface to Alarm.com.
I tested on my raspberry pi and it works great - super fast…
-
#### Issue
Hey,
I encountered a strange behavior in my setup for the second time now. After homebridge-hue lost connection to the Hue bridge (v2, latest update), in the case of today, because …
-
### Prerequisite
- [X] Yes, I've read the readme completely.
### Cache
- [X] Yes, I've cleaned accessory cache and the issue still exists.
### Version
v1.7.0-beta.49
### Device Infomation JSON F…
-
When attempting to arm or disarm, I will get "Arming" (sometimes "Waiting" for a second or two), within HomeKit, but it never actually instructs the ELK M1G to arm or disarm. Below are the errors we s…
-
Confused, why does it say "Connected to Alarm!" but then tells me I can't log in? Am I doing something wrong here? Also, under password, do I put the password to the IP device (IP150) or one of my use…