-
Sorry for the "issue" submission.
Here is the log from the app
```
(.venv) me@pzw-1:~/i2c_2_mqtt $ python3 mqtt2i2c.py config.yaml
Sent HA switch discovery {"name": "pzw-1", "state_topic": "I2C/…
-
ie, if power has been cycled, Home-Assistant isn't aware of the current state of the on-board relay
-
### The problem
OTA Compiles and the installs. Device reboots and does not com online. Logs starts after the update and below stops but continuous ping fails. The device comes back online after about…
-
### The problem
Edit: made a few changes and ran more tests after noticing additional device classes and measurement types, but the issue persists. Please see the additional comment that follows.
…
-
The vast majority of peer to peer communication protocols have some form of initial handshake. It allows both sides of the conversation to identify each other and exchange information about the featur…
-
### The problem
When Feedback Cover have configured close_endstop, cover is closed and then close_endstop change it's state to OFF without opening cover with ESP (for example manual open or even ba…
luzik updated
1 month ago
-
Would it be possible to change the firmware so the momentary switching of 5v and RST turns the relay off as well as on? I'm currently working on a 600x600x600 printer that had a board with a built in …
-
when running the following code repeatedly (setting the GPIO pin to 1 -relay off multiple times), occationally i hear the relay click and get a momentary contact on. I also see a GPIO-Admin: could no…
-
Hello,
On my **Atomstack A10 V2**, I would like update/upgrade the firmware for implement air assit.
I think mainboard can to do. Because "**Air Assit**" is write on this one. But i think the orig…
-
Bill of Materials for Physical Device:
- 2 x Raspberry Pi 3
- Due to the way the RFID scanner and relay(s) are hooked up, it would probably be more cost effective to hold off on *two* RPi3s for …