-
**Describe the bug**
The compilation could not be completed,
The compilation process stops at one step and cannot continue
**To Reproduce**
Possible cause of failure is Microsoft Windows sys…
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…
-
OK, I use the library in vscode with platformIO, I just install the library adafruit_gfx, and adafruit_st7789, and some libraries depend on it, it install automatically.
After it, I start to use it l…
-
### Bug Description
I got a problem with Anet a8 plus, My capacitieve sensor goes outside my bed to measure, when I try to auto level.
I use marlin 2.0 and search everywhere for the solution. …
-
Error at compilation:
"Multiple libraries were found for ..."
for all the libraries that the sketch is using.
I checked if there was multiple libraries by searching in the explorer. The only du…
-
Uncertain which update caused the display to stop functioning, however an older MKS Robin only build also no longer works, which makes me suspicious of some sort of platformio update that has broken s…
sakza updated
4 years ago
-
BLTouch is not centering to the build plate on z_safe_home. The position it homes to is center of build plate + the nozzle offsets. This results in the printer head homing to the front left corner of …
-
-
There's now a HAL published on crates.io: [`embedded-hal`][] ([Introduction blog post][brave-new-io]). :tada:
[`embedded-hal`]: https://docs.rs/embedded-hal/0.1.0/embedded_hal/
[brave-new-io]: htt…
-
### Bug Description
Nozzle to probe offset is ignored. Probably on X and Y axis.
### Configuration Files
Not relevant
### Steps to Reproduce
Compile latest 04c4c6004e752582235357b14aebd…