-
Hi.
First of all, amazing work! I have been playing around with the quad and it is working pretty well.
But I have a question, hope you can answer me:
- what type of controllers are implemented? Ca…
-
Would it be possible to add a module that calculates a sub-orbital hop? Like the the landing AP with the ability to select from the map/type coordinates and then have MJ calculate the required burn a…
-
```
What steps will reproduce the problem?
1. Start it up
2. Raise throttle, start roll
3. Take off
What is the expected output? What do you see instead?
Any flight simulation, even 2D red-baron, ne…
-
It says it should only be able to push a plane to mach 2.4 (800ms), I'm getting to close to mach 3.9 (1180ms)
Maybe the change from 1/3 to 4/5 the thrust of the KAE version was a bit to much.
-
Hi,
I am working with the IEA 22 MW floating semi in OpenFAST. I ran a case with constant wind speed at 11 m/s. The average rotor thrust is 4.1E3 kN, which is a lot higher than what I can see from…
-
Hi all,
I am currently comparing results between OpenFAST and Bladed for FOWT through the IEA 15MW wind turbine atop UMaine platform. But I found some differences existed in the platform pitch and…
-
I want to run IEA10MW reference wind turbine model with and without Beamdyn. I'm using OpenFast-v3.5.0 and ROSCO-v2.7.0. The model has run successfully without Beamdyn. However, I couldn't run the mod…
-
We should make clear that are not yet another HPO library.
I suggest we should start documenting examples or areas where black-box optimization is applied.
-
Undefined control sequence. \makeincovertitle
Undefined control sequence. \makeincovertitle
Undefined control sequence. \makeincovertitle
Undefined control sequence. \makeincovertitle
Undefined co…
-
Hello,
Running a fresh install of RO and the latest FAR binary from master branch. The install is than 24h old, and I've got some strange behaviour from FAR. I have also tried the release version 0…