-
Hi, I got a batch of boards made and disappointed to find that only DIO0 is brought out to a pin.
I've had to bridge over with wire to get DIO1 connected so LMIC will run.
It'd be great to see…
-
Would it be possible to support this particular board with the mcci arduino-lmic stack?
https://heltec.org/project/htcc-ab01/
It consist of a ARM Cortex M0+ microcontroller plus a Semtech SX LoRa …
-
Dear Team,
I did a lot of work on the SX1276 driver to make it more generic, to support RFM95, MuRata, Heltec and other 1276 based chipsets and to fix issues. What I see, you do similar changes in …
-
Arduino Pro Mini Atmega328P 3.3V 8MZ
Arduino IDE Version 1.8.15
MCCI LoRaWAN LMIC Library Version 4.0.0
I am trying to setup a lorawan device using Arduino Pro Mini and RFM95 module according to …
-
When I set up RGB OFF it stops with "-> Enter state Measure".
My setup is Cube Cell, HX711, DHT22, no One-wire
I have tried to set "#define THERMOMETER_COUNT 5" to "0", but then the compilation fai…
-
Hi there,
I have been testing the LoRaWan example for the Wireless Stick Lite V3 (ESP32S3 + SX1262), specifically focusing on sending messages to The Things Network (TTN). Here are a few observatio…
-
We will need a working LoRaWAN network to see what we can do with it and how we can use it.
-
ESP32_LoRaWAN/examples/OTAA_OLED/OTAA_OLED.ino
The Example compiles fine. LoRa Sending works like a charme and data arriving in TTN. But the OLED stays dark. I have to something special to get the …
-
Hi,
I'm experimenting with my sensor, however it is not completely clear to me how I would proceed with connecting the sensor to LoraWan. Is this a possibility of completely out of scope of this pr…
-
Hi there!
I tried your library on my mac and it works fine. When I tried it on my windows 10 laptop, it throws the error below. I found some workarounds for this by disabling the McAfee antivirus a…
Buzda updated
3 years ago