ARMmbed mbed-semtech-lora-rf-drivers issues

ARMmbed / mbed-semtech-lora-rf-drivers

Semtech's LoRa RF drivers for mbed OS

Other

32 stars 25 forks source link

issues

Newest

Newest Most commented Recently updated Oldest Least commented Least recently updated

SX1262 pinmap not found for peripheral

#59 krakush closed 2 years ago
4
TCXO control

#58 evandavey opened 3 years ago
0
Fixes for compatibility with mbed without RTOS

#57 danielkucera opened 4 years ago
0
Fix Fifo Pointer in Continuous Mode

#56 Eric-A-Marks closed 4 years ago
0
BUGFIX: MODEM_LORA rx continuous was timing out

#55 thendrickson closed 4 years ago
0
Mbedos6 fixes

#54 kivaisan closed 4 years ago
0
SX1262 times out of rx continuous (class C)

#53 thendrickson closed 4 years ago
4
SPI_FREQUENCY configuration points to wrong define

#52 MortenGuldager closed 4 years ago
2
Add Semtech drivers configuration as mbed-os component ?

#51 jeromecoutant closed 4 years ago
9
FRF Calculation Inaccuracy

#50 mattbrown015 closed 4 years ago
3
Test CN470 on Mbed-OS

#49 ccchang12 opened 5 years ago
1
Doesn't play nice on shared SPI bus

#48 thendrickson opened 5 years ago
1
reduce default sx126x spi clock freq

#47 bentcooke opened 5 years ago
0
SX1278 support?

#46 ccchang12 closed 5 years ago
3
Replace floating point with integer operations

#45 gpsimenos closed 5 years ago
3
SX1262 0% Downlink Packet Success Rate for LoRaWAN Class C

#44 snelson-senet closed 5 years ago
4
Make it possible to use shared SPI module

#43 danluck closed 5 years ago
2
Full SX126X support

#42 thendrickson closed 5 years ago
3
SX1276: Ensure that opmode transition to sleep succeeds

#41 teijokinnunen opened 5 years ago
0
SX1276: Dynamic TCXO control

#40 teijokinnunen opened 5 years ago
0
Read timeout

#39 evandavey closed 5 years ago
5
Hard Fault while using 5 DIO pins

#38 trowbridgec closed 5 years ago
6
SX1262MB1PAS not receiving on RX1

#37 snelson-senet closed 5 years ago
2
Introducing SX126X radio driver

#36 hasnainvirk closed 5 years ago
0
Allow setting SPI frequency in radio constructor

#35 janjongboom closed 5 years ago
2
Need to be able to set SPI clock speed

#34 janjongboom closed 5 years ago
2
SNR not exposed correctly

#33 maxgerhardt closed 5 years ago
5
Using new rtos::Thread APIs

#32 hasnainvirk closed 6 years ago
0
Adding support for low power timeouts

#31 hasnainvirk closed 6 years ago
0
Deprecation Warnings Created by Changes to mbed-os

#30 mattbrown015 closed 6 years ago
2
Use Configuration to Set Variant Type if ant_switch Not Connected

#29 mattbrown015 closed 6 years ago
0
Duplicate work on the SX1276 driver

#28 helmut64 opened 6 years ago
3
Setting the SX1276 Variant Type

#27 mattbrown015 closed 6 years ago
11
Correcting buffer size and tx timer units

#26 hasnainvirk closed 6 years ago
0
Incorrect Time Units for set_tx_continuous_wave

#25 mattbrown015 closed 6 years ago
3
Inconsistent Buffer Size Specification for Send

#24 mattbrown015 closed 6 years ago
6
TX timeout issue fix

#23 hasnainvirk closed 6 years ago
1
Removing software RX timeouts in RX chain

#22 hasnainvirk closed 6 years ago
4
Fix correct pin check for rxctl

#21 kivaisan closed 6 years ago
0
Possible Typo in `SX127x_LoRaRadio::set_low_power_mode`

#20 mattbrown015 closed 6 years ago
2
Remove obsolete FEATURE_COMMON_PAL flag

#19 kivaisan closed 6 years ago
2
Remove usage of DEVICE_SPI flag

#18 kivaisan closed 6 years ago
0
Make it Possible to Supply the Stack Mem to RF Drivers

#17 mattbrown015 closed 6 years ago
11
Change static variables to class members

#16 kivaisan closed 6 years ago
1
Remove product specific variables and target flags

#15 kivaisan closed 6 years ago
3
add support for the RFM95 board, fixes #13

#14 sillevl closed 6 years ago
3
rfm95 support

#13 sillevl closed 6 years ago
4
Fix IAR compiler warnings

#12 kivaisan closed 6 years ago
0
Checking for pins being NC before writing

#11 hasnainvirk closed 6 years ago
0
Add TCXO pin for SX1272

#10 kivaisan closed 6 years ago
0