-
I can't find any board images or diagram.
Please upload creality
-
- Investigate usage of hawt.io
- Needs to output wiring diagram (fritzing)
- Output mobile friendly user interface for deployable (camel) application
-
Need to understand how current measurement works on the 7050 chip, calculate the resistor values for the voltage dividers, and update:
1) voltage-dividers.odg
2) power-test-config.odg
The voltage…
-
Hi If you are able to add support my boards
I can send you this hardware
https://hackaday.io/project/184965-picomputer-zx-pocket-zx-spectrum (ST7789 IPS LCD)
https://hackaday.io/project/183398-retr…
-
## Hardware
* [ ] ESP8266
* [x] ESP32
* [ ] Raspberry Pi
Modelname: ______
Retailer URL: ______
### nRF24L01+ Module
* [ ] nRF24L01+ you verified this is a **Plus model** capable of t…
-
### The problem
Same issue as #90647
The current valve positions of floor heating actuators are not available for logging.
The documentation shows that this is intentional:
There is no need …
-
Hi. Apologies for logging this as an issue. Wasn't sure how else to reach out to you.
Very interested in your project.
I'm an absolute beginner to arduino. Don't know how to read the diagram in your…
-
Firstly, I would like to thank you for making this project public and open source under GPL liscence!
Secondly, I would like to thank you for sharing your research with regards to the block diagram…
-
Bob's mods have been around for a long time and touching something as fundamental as science pack recipes is possibly controversial, but when comparing to other science progression systems, Bob's Mods…
adoa updated
8 months ago
-
Design a circuit that will allow the ESP32 MCU to control the power up sequence of the servo motor controller. The steps in the power-up sequence will (roughly) 1. ESP32 does boot up process, 2. Provi…