-
Moin, erstmal tolles Skript. leider scheitert meine Einrichtung des Mi Smartfan 2.
Ich hab die Def Datei eingefuegt und ioBroker neugestartet. Er findet diese auch, aber bekommt dann den Error aus d…
-
I use custom controls for my printer using custom control editor.
The first container of my controls is shown below the camera view on half the screen. When I clink on it it opens a full screen view …
-
I've been using this since it has better controls for voltage and clock than CoreCtl(now uninstalled) from what I saw. However I noticed once I apply my settings(clock 1905MHz, max voltage -100mV, sta…
-
pwmconfig show errors and skips pwm controls:
```
Found the following PWM controls:
hwmon4/pwm1 current value: 0
cat: hwmon4/pwm1_enable: Permission denied
/usr/bin/pwmconfig: line 1…
-
I have a GE fan control switch:
http://products.z-wavealliance.org/products/930
After adding the switch it shows up as a light dimmer. It does work, but homebridge-zway also sees it as a dimmer,…
-
## Expected Behavior
If a policy choice is affecting the happiness of a faction, you should have the agency to deal with it.
If you cannot have the agency to deal with it, it should not affect the h…
-
### Objective
Enable support for some other fan curves to maintain lower fan speeds.
### Initial Implementation Requirements
- options should be selected via configuration
- options should e…
-
The side fan command on Guppyscreen for K1 is not calibrated. The fan turns on from 68% to 100%. It should be calibrated from 0 to 100 like the stock UI.
These are the variables for K1 fans:
varia…
-
Pressing UP when the cursor is on the first item of the main page, does select the first item, but does not scroll down all the way.
GIF demonstrates it.
The fan controls are not visible while still…
-
Few feature ideas:
1. Filament controls:
Add extrude and retract controls to the filament menu with 1, 5, 10, 50mm and speed options
2. Filament preheat temperature presets:
Somet…