-
**Describe your question or issue**
I want to move from matthijskooijman/arduino-lmic to mcci-catena/arduino-lmic for my atmega328p-based project due to LoRaWAN specs compatibility issues.
Howe…
-
Hello! I'm just starting a project and was planning on using a rfm95 lora radio. It looks like you don't yet have support for lora, but I was wondering if you have put any thoughts into it yet. I'm no…
-
**tl;dr: The example works on a Feather M0 900Mhz with v2.3.2, but not with v3.1.0.**
First: Huge fan of this project and eternally grateful for everyone's hard work. Thank you very much.
Quit…
-
Hi,
Firstly, many thanks for your great work developing and maintaining this useful library. I used this library in a project to control a device by sending command using LoRa. The first prototype us…
-
Hi jgromes,
First of all thank you for your library!
Recently purchased two LAMBDA62C modules with SX1262 chip. (REV2, 915MHz)
It has separate TX & RX enable pins.
DIO2 is NOT connected to RF_S…
-
Is enabling internal pull up required for the reset pin? Or is simply setting to input adequate? Use case is for a board that lacks internal pull ups on inputs pins.
![image](https://user-images.gith…
-
**Describe your question or issue**
I have a device working with a private Chirpstack and MCCI arduino lmic using OTAA. Everything seems to work except that I see extra empty messages being sent from…
-
**Describe the bug**
When using more than one MS80302 pressure sensor, one of the sensors reports temperature about 10 degrees Celsius low. Pressure readings are accurate for both sensors. Only the t…
-
Hi,
Does somebody has a working example with this node, using LMIC library and TTN?
Can't get it working (EV_JOINING, nothing more). Is maybe my pin map incorrect?
```
const lmic_pinmap lmic…
-
The Feather M0 LoRa draws about 0.37mA of current when idling using the sleepydog library. It would be ideal if we could push this down much further to the 0.01 or even 0.001 mA range and we should be…