-
[Product page](https://www.bosch-sensortec.com/products/motion-sensors/magnetometers-bmm150/)
[Datasheet](https://www.bosch-sensortec.com/media/boschsensortec/downloads/datasheets/bst-bmm150-ds001.pd…
-
Hi!
I'm learning embedded rust and currently trying to control the compass leds of the STM32F3 discovery board using the magnetometer data. I was able to setup everything and I get logs from the a…
-
Im using the asukiaaa library and printing x, y, and z mag values to the serial monitor for testing purposes. Everything works fine at first but then negative values are half displayed on a different …
-
In some locations (most notably tunnels), the magnetometer gives out unreliable data. Usually, this is marked by very low values (all axis are
-
```
What steps will reproduce the problem?
1. Setting USE_MAGNETOMETER == 1
What version of the product are you using? On what operating system?
IMU v2+; Windows 7
Please provide any additional inf…
-
```
What steps will reproduce the problem?
1. Setting USE_MAGNETOMETER == 1
What version of the product are you using? On what operating system?
IMU v2+; Windows 7
Please provide any additional inf…
-
```
What steps will reproduce the problem?
1. Setting USE_MAGNETOMETER == 1
What version of the product are you using? On what operating system?
IMU v2+; Windows 7
Please provide any additional inf…
-
I try to config the magnetometer and i get about 70%
In my gaming room i get 60% and in my sleep room i get 75%
I read here a post and in the google groups about this issue and i think there is no…
-
As I understand it, the MAG3110 and LSM303 ranges are +/- 10 and nearly +/- 50 Gauss. They return 16bit signed integers with nominal units of 1 and 1.5 milliGauss. I think that's +/- 1000 and +/- 5000…
-
Hello
Thanks for all of this work. I'm really happy that you have made this project!
I'm experiencing some trouble on MacOS. For some reason, I can't calibrate the magnetometer anymore.
When I plu…