-
Hi there,
first of all thank you for your package. I have recently started playing around with a rpi 4 and wanted to connect a mh-z19b with your python package.
I made sure the serials are avail…
-
I've updated firmware to **ESP_Easy_mega_20210114_dev_ESP8266_4M1M**, and after that i've tried to configure Display - **OLED SSD1306/SH1106 Framed** with following Line:
Line 1 : `[HDC1080#Tempera…
-
Hi,
I'm using your lib with a rpbi 4 and it needs some fixes.
¿Can I contribute to the community fixing them?
-
Hello WifWaf,
on https://revspace.nl/ there is a indicator how to change the cycle of MH-Z19b.
Default is 5 seconds which will also be responded by :
int MHZ19::getCycle()
{
/* check get Cyc…
SFeli updated
3 years ago
-
Hi,
Do I need to make alteration in the code (except for the pins ofcourse) to get this to work on an ESP8266 board.
I only get a question mark for the moment..
```c++
/*------------------…
-
I recently ordered 3x MH-Z19 sensors from banggood. Because I wanted to construct 3 supplementary IOT CO2 sensors (refer to my project https://github.com/hixfield/HixCO2TemperatureIRBlaster). However,…
-
when i run hw_get_values.ino
i am getting error code:5
Please help
connection:
MH-Z19b | Esp8266
Vin | vin
GND | GND
Tx …
-
Hey,
I received my MH-Z19B and connected it to my raspberry.
I ran a `pip install mh-z19` and when I execute `python -m mh_z19 --all` I receive the following output:
`{"SS": 0, "UhUl": 0, "TT":…
-
Hello,
This is just a quick question:
In the project Readme says "ABC must be disabled each day, however this is handled by the library."
Is this correct? So the MHZ19B re-enables the auto cal…
-
- [x] Instantiation of rev1.1 design database
- [x] bug fix: Rotate the OLED display connector 180degree
- [x] Modify the connector for the new MH-Z19-C with cable connector
- [x] Review placement …