-
I flashed this firmware to my Prusa and my printer is not showing the correct temperature. Thoughts? Unless at room temperature (~23°C) the thermistor should be saying 60°C.
-
We have two different versions of Marlin on the Kossels and Prusas, and four different calibration settings.
- [ ] Find out which Marlin versions the manufacturer versions were forked from (not requi…
-
For the DIY printers, under Overview add a page that says -Firmware-
Then link the guide: http://www.diyelectronics.co.za/firmware/RAMPS_XLoader_Guide_rev1.pdf
Look in the tree of http://www.diye…
-
Printer type MK3S with mods
Printer firmware 3.13.2
Operation from LCD
Describe the bug:
I have a mostly MK3S printer. It started life as scratch built i3 but upgraded with kits from Prusa to M…
-
### Printer model
- [X] MK3S/+
- [X] MK3
- [ ] MK2.5S
- [ ] MK2.5
### Describe the feature
In the older firmware versions i could use "load filament" even when filament already had been loaded. the…
-
It would be beneficial to have a possibility to install the latest PrusaLink (currently 0.7.0) on Original Prusa Mini+ with ESP Wi-Fi module with already installed latest firmware (currently 4.4.1).
-
### Version
Prusa slicer 2.2.0
### Operating system type + version
Any
### 3D printer brand / version + firmware version (if known)
Any
### Behavior
I sometimes have prints where the draft-…
-
### Description of the bug
While installing version 2.7.4 on the Mac with an M1 Ultra chip, I was asked to select which printer I was going to use, I selected the Prusa XL 2T I have. A couple of st…
-
**Printer type** - MK4
**Printer firmware version** - 5.12
**Original or Custom firmware** - Original
**Optional upgrades** - none
**USB drive or USB/Octoprint**
USB Drive
**Describe the…
-
Using firmware 3.14.0 this plugin works for MK2.5S.
Wold be nice to update the compatibility list in the description.
Suspected working: All Prusa RAMBo 13a printers with firmware 3.14.0+