-
I'm running into a strange issue with my MM configuration.
I am pulling data from 4 different Google calendars on my configuration - two of them are calendars from the same Google account. One of t…
-
Qemu 2.6 added support for raspi2. But I couldn't get the uart01 example run correctly using raspi2.
The steps I took was:
- Edit `uart01/memmap` and change origin to `0x10000` (which is the address …
-
20201117 ミーティングにて、現状の chirimen.org をアーカイブにした上でこのリポジトリでメンテしているチュートリアルサイトを chirimen.org に設定することになった。
- [x] 本リポジトリ名称を tutorials から chirimen.org に変更
- [ ] chirimen.org を現 tutorial.chirimen.org (このリポジト…
-
**systemd version the issue has been seen with**
https://github.com/systemd/systemd/pull/15891/files
Above is merged leading to following in master.
https://github.com/systemd/systemd/blob/976efe1b…
-
I have a number of vehicles I have built which run Raspberry Pi's hooked up via the serial port to a Pixhawk. Mavproxy is configured to start at boot. Some non-zero percentage of time mavproxy starts …
-
I know this maybe kind of heavy for pi, but just want to ask the possibility.
If it's possible, will wayland and VC 4 improve the performance?
-
Would be nice to have support for building SuperSlicer under a Ubuntu ARM 64 architecture. So we can do some server-side slicing it is supported in PrusaSlicer i believe.
-
I have updated to 1.2.7.
Unfortunately all printer are failing after some while because printer is stuttering (nozzle does not move for some seconds).
In the printing terminal i can see "Display i…
-
Hi
Is there a noob step by step manual to install on raspberry?
-
Added the module to my config file but when I run Magic Mirror all I see is a Microphone crossed out. The status doesn't seem to change at all.