-
So I checked everything I could imagine and it doesnt come out. The thing is that if I manually move the filament, it comes out melting from the extruder.
That means that every mechanical part work…
-
**Is your feature request related to a problem? Please describe.**
I would like all the jumpers to be documented in the 2.0 manual. Including X-Diag, Y-Diag, Z-Diag, E0-Diag, etc.
**Describe the s…
-
How can I fix this bug in Marlin bugfix-2.x.x?
`Error: Unknown environment names 'MKS_ROBIN2'. Valid names are 'MightyBoard1280, MightyBoard2560, DUE_USB, DUE_archim_debug, STM32F070CB_malyan, maly…
-
**Is your feature request related to a problem? Please describe.**
My SKR Mini E3 v1.2 is bricked and If I had the bootloader binary file I would be able to flash it again using a ST-LINK for example…
-
Btt ups doesn't work on versions above 2.0.5.
I was able to compile and run it with Marlin version 2.0.5, but it doesn't work stable. I could not manage to run it on higher versions.
-
I recently got an Ender 3 V2, but one of the stepper motor drivers on the motherboard is broken. I have an old ender 3 running SKR mini E3 board and works pretty well, so is the new SKR mini E3 V2 boa…
HYC23 updated
6 months ago
-
Will there be a example config for CR-10 with V3 board installed. It is sold stating that it is for E3/E5/CR-10. But it only has examples for E3 and E5. The latest example for CR-10 is V2.
I would …
-
Hi there,
I am trying to configure the 1.2 board for use on a Voron 2.4 running Klipper. I seem to have everything going well until I boot up with the motors connected. This is the error I get with…
-
### Description
Replaced the stock Creality board with the SKR mini E3 v2.0 on my Ender 5.
After the install used the firmware for Ender 5 (https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/blo…
-
So a few days ago I installed my SKR mini E3 on my Ender 3 with BLTouch, and after some initial troubleshooting, got it printing. Yesterday afternoon, I started getting a TMC Connection Error.
I ha…