-
A problem with current belt drive is that it does not run parallel to the horizontal plane.
That means two problems.
1)
When the belt is angled from the horizontal plane, the transport distance of …
-
_Written & Organized by 悦子yuezi
Issue Date: 2024/09/06_
#### 1/16 Post-Impressionism
**Impressionism**
developed in France in the 19C. century and is based on the practice of pain…
-
Dear developers,
I was using PySPH on my old GPU (GeForce GTX 680) for a while and I recently started using it on a newer GPU (NVIDIA TITAN V) as well. Unfortunately, there are some strange issues …
-
Dear all,
Greetings! I am simulating near-wall bubble collapse and am using pressure disequilibrium model with infinite relaxation. I have read [here](https://www.researchgate.net/publication/36304…
-
It would be nice to have the ability to control the flow of every entry where you can set the extrusion width and speed.
This way I can print inner perimeters at higher speeds while maintaining the c…
-
**Is your feature request related to a problem? Please describe.**
If I print a part with a height of 60mm using 0.25mm layer height and an initial layer height of 0.1mm the part will only be printed…
-
Upon my first poor experiences with my new 3D printer I was keen on improving my results. My analysis showed me one topic, which I have analysed a little bit deeper: the applied flow math.
Within the …
hoh61 updated
6 years ago
-
If sigma is temperatureDependent, then there may a tangential gradient of sigma. Perhaps _surfaceTensionForce()_ in **surfaceTensionForceModel.H** is lack of the tangential gradient term?
-
The .NET BCL includes a low-end, raw ClientWebSocket class dealing at the frame level with the protocol. You have to pass it `ArraySegment`, you have to assemble frames into messages, manage, pipeline…
-
Hi,
I am using a CNC Shield v3 with GRBL 1.1. I have dual Y motors, one being cloned from driver A. I have an end stop on the Y motor that is using the Y driver. I would like to add another end stop …