-
control arduino via HTTP
-
```
What steps will reproduce the problem?
1. Arduino Mega 2560 Pin Above 13 no response.
2.
3.
What is the expected output? What do you see instead?
What version of the product are you using? On w…
-
```
The is a feature request:
With the addition of ExtendedAnalogData in Firmata 2.2, it is possible to send
PWM values greater than 8 bits (assuming that in the future Arduino, Wiring,
etc may sup…
-
I have installed the plug-ins and the animated LED and Pico sprite work, but there is no successful connection to the Arduino that has Standard Firmata installed on it. In the Chrome browser console,…
-
Hi,
I like the design of the board, but I was thinking I could free up 2 more IO pins from arduino if I used the RX/TX instead of i2c to talk to pi, and this would also allow me to write the "firmwar…
-
I would like to use the [BigEasyDriver](https://www.sparkfun.com/products/12859) to drive a stepper motor from the Arduino.
I've chosen Cylon over Johnny-Five because, although newer, I believe Cylon…
-
Enc28J60-based shields are few dollars cheaper and are widely spread.
Edit [stubs](https://github.com/4ntoine/ArduinoCommander-ethernet/tree/master/Ethernet) to add Enc28J60 support.
Uncomment `//#i…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
Hi guys, checking the proximity sensors currently supported by Johnny-Five, I can't see a controller that could work with the [Adafruit VCNL4010 Proximity/Light sensor](https://www.adafruit.com/produc…
-
```
Hi,
Glue doesn't seem to work with the standard Firmata 2.1 thats now supplied
with Arduino 17.
I get "Socket Connected" but then no response. Do you plan to update the
Glue software for 2.1 ?
…