-
I purposely had a SNES/SFC input viewer built for the sole reason of fixing this damn problem. I had been using the programs "Input Viewer", & later "ButtonMash", through USB2SNES (QUSB2SNES now). But…
-
My code:
```
import numpy as np
import gym
from gym.utils.env_checker import check_env
import robosuite as suite
from robosuite.wrappers import GymWrapper
from robosuite import load_controlle…
-
Paul B from Dallas Makerspace says:
> I was wondering if you guys would want to integrate the access controller we're
> using - with seltzer. I'll send you a 4-door controller for free. You might nee…
-
Currently there are only three types of wall (cobble, desert cobble, mossy cobble), with a fourth soon to be added (ice), I'm wondering if more should be added, such as marble, granite, obsidian, etc.…
-
I would like to get this plugin to work with Homekit Controller in HomeAssistant. However, it require unique serial number for each accessory.
The current set up for this plugin use the same serial…
-
### Description of the issue
Since upgrading to 1.39.0-1 I cannot access Zigbee2MQTT's frontend, getting "502: Bad Gateway" instead. Other addon frontends are accessible via ingress. There's nothin…
-
# Problem/Motivation
> I have a Z-Wave gate controller (Nice IBT4ZWAVE). When I tap a button in HA to open or close the gate, its state does not update until the gate finishes the movement (which tak…
-
Hi, are there plans to implement relay control to this plugin?
I have a garage door on a Control4 relay (wired into the green relays on the back of the EA3) which isn't visible in the system at all…
-
I am looking at configuring am OpenEVSE charger for use at home. Home being very visible near the sidewalk in a busy city, I'm hoping to have some locking for my charger so nobody can roll up and just…
-
@washcroft
I can't be grateful enough, it's been 3 years now since I have been using your project as my gate controller. I was wondering if the following updates are possible. For the most part, I…