-
Use '3C286' for xcal while excute worker polcal, the polarization angle(PA) is not correct.
'setjy' from the log file had set the polarization information of 3C286 to the model seems no problems, but…
-
To run on iOS, the code can (currently) not depend on community codes.
FRESCO uses FiMap and optionally a stellar evolution code. Replacing FiMap with a python mapper for plotting the stars should be…
-
Just by looking at the manual, it seems like that it is discouraged to use the Rust-library directly? Is there any reason for that? If not, it would be helpful, if there were a section on that in the …
-
When I open website from mobile phone I get issues, check screenshot below:
2. Check the Show Data box in the Spatial -> 3D panel (it will say
from after step 1 is done)
3. A si…
-
### New feature type
New infrastructure or infrastructure enhancement
### What is this new feature?
Right now many plotting scripts repeat various common calculations, such as vertical interpolatio…
-
If the build mode with terrain editing is enabled, the build queue does not inherit this property. This, in turn, leads to a high concentration of attention, in order to properly route electricity.
…
-
* dask-ms version: 0.2.6
* Python version: 3.9.7
* Operating System: Manjaro
Hello, I am trying to calculate the psf/dirtybeam analytically with dask-ms and also gridding the data. However, to ca…