-
### Description
I have an all metal hot end, and am trying to print Nylon at 300C. I increased the `HEATER_0_MAXTEMP` to 330 to start with, and then also bumped it up to 350 as a second test.
B…
-
Hi
I am getting
**Unable to write tmc spi 'stepper_x' register GLOBALSCALER**
error when I try to home steppers on SKR 3 EZ, using EZ5160 drivers
below is my printer.cfg config, pretty standard…
-
### Feedback
One example among many: https://www.home-assistant.io/integrations/climate
I think the documentation would be more clear if "Required" (Yes/No) were used instead of "Optional" (Yes/No…
-
First of all - thanks for this wonderful ESP implementation to get the Truma "under control".
My setup is a Combi 4E (C4.01.02 / 50.00, H1.01.00 / 340.0A) together with a dedicated esp32. Further sen…
-
Regarding controlling the heater to achieve consistent (non-wandering) temperatures.
Using PWM (pulse width modulation) is a practical and known method for controlling analog devices to vary outpu…
-
Using version 1.3.4 my unit shows up as the temperature set to 130C instead of 130F.
The outlet temperature looks correct. It would be nice if we could control which unit is used as often room temper…
-
### Prerequisite
- [X] Yes, I've read the readme completely.
### Cache
- [X] Yes, I've cleaned accessory cache and the issue still exists.
### Version
1.7.0-beta.51
### Device Infomation JSON Fi…
-
This plugin is awesome! Just need help with one thing:
Just purchased and installed a Heat Storm HS-1500-PHX-WIFI Infrared Heater, Wifi Wall Mounted in my garage and connected it to WiFi and set it u…
-
We need provisions to test board assembly using https://github.com/rusefi/stim approach
* output raw analog on a new CAN ID every second even in PROD mode
* receive CAN message to switch into HW Q…
-
Both of these applications should make use of the entire Instrument Framework. Right now only TC uses Remote Control SMO subsystem to enable remote control of the heaters. The full stack should be imp…