-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
~~I don't own an [STK600 board](https://www.microchip.com/en-us/development-tool/ATSTK600), so I can't confirm this.
But from the looks of it, the STK600 can only be used in ISP, HVPP or HVSP mode w…
-
# Intro
This is a followup on https://github.com/jeanthom/openocd-dirtyjtag/issues/2#issuecomment-769485719, focusing a working setup with DirtyJTAG+[Espressif ESP32S2 Saola-1 dev board](https://do…
-
Hello,
I am trying to update firmware (following the document https://github.com/USIWP1Module/USI_I-NUCLEO-LRWAN1/blob/master/preloaded_firmware/WM-SG-SM-42%20Update%20Preloaded%20AT%20Command%20FW…
-
this is a continuation of https://github.com/john30/ebusd/issues/891 as it was misplaced there.
the recently [released firmware](https://adapter.ebusd.eu/v5/ChangeLog#20230903) is capable of analys…
-
Hello,
any hint is appreciated, I'm kind of desperate!
I'm using latest Arduino IDE 1.8.19 under up-to-date Win10 64-Bit and set up everything exactly as described in Readme. This is a fresh ins…
-
Hello,
I use UBUNTU 22.04.01 LTS
I tried to install Gap8_SDK but i have an issue with openocd.
After Autotiler et license agrement i had this error
Makefile:5643: avertissement : surchargement…
-
能正常刷写固件,但是刷写完成后屏幕没有显示,电脑安装了驱动也没有识别到串口,我不知道是不是我的电路有问题,有没有遇到这样的情况,该如何排查?
clion刷写日志
Open On-Chip Debugger 0.11.0
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen…
-
When using Keil uVision with a ULINKplus debug adapter on a M031 target, the reset type "HW RESET" does not work. Opening a debug connection fails with the error "Could not stop Cortex-M device! Pleas…
mf301 updated
2 years ago
-
```
OpenOCD JTAG (Flyswatter) support would be nice.
http://elinux.org/BeagleBoard#JTAG
Steps necessary for this:
* OpenOCD compatible JTAG hardware interface with FTDI's FT2232 chip, e.g.
Flyswat…