-
### Is your feature request related to a problem? Please describe
I using BTT relay as safty measure, for that I need to setup PE4 pin to true during boot to avoid the relay cut the power in the mean…
-
The board I bought worked for a while then died suddenly, upon closer inspection I found a hardware flaw in the design. The problem is that when the transistor that turns on the relay is not powered t…
-
Bill of Materials for Physical Device:
- 2 x Raspberry Pi 3
- Due to the way the RFID scanner and relay(s) are hooked up, it would probably be more cost effective to hold off on *two* RPi3s for …
-
I am helping someone set up a pool controller.
We are trying to set up Generic devices for Temp. We can create the generic device. But when we go back in to edit it the save and delete buttons are…
-
The vast majority of peer to peer communication protocols have some form of initial handshake. It allows both sides of the conversation to identify each other and exchange information about the featur…
-
Hello i was able to configure esphome with the ESP32S3 t-relay....now i've connected an expansion board but i cannot find the way to configure the YAML file to make that work. Can you help with this?
…
-
Task list for hardware changes
# Ideas
- [ ] Attachments (power outlet, frame mount):
- [ ] detachable ventilator
- [ ] detachable lamp
- [ ] integrate wireless phone charging
# Fixes w…
-
Hi,
I get the following issue with one of my two boards.
This happens after several power up cyles.
The other board is working perfect.
If I flash the board again, it is working but again after …
-
I have been looking for a way to control a denkovi relay module board V2 which uses the MCP2200 chipset.
All the examples I've found have used pyusb to enumerate the device, but it does not see it on…
-
### Proposal abstract
Upon FCMP++ hard fork activation, validators should ignore the `unlock_time` field retroactively for all non-coinbase transactions posted to the chain after a certain height. …