-
When engaging any of the stepper motors (i.e., X axis, Y axis, Z axis, Extruder) the fan remains off.
**Expected behavior**
Fan1 (control board cooling fan) should run when any of the stepper …
-
Hello,
I'm interested in your project, but i'd like to be sure to understand some things.
If i use an ESP 8266 and a Stepper motor driver (see link below), will i be able to build a standalone irr…
-
Please add support for uStepper S made by ON Development (https://www.ustepper.com/)
uStepper S is an Arduino compatible board, with integrated stepper driver and 16-bit rotary encoder, mounted di…
-
hello world
anyone can help me run my vexta stepper motor contains 5 wires connection by pentagon wound i have a driver (b0655180) i attach some picture for stepper motor and driver**
![Einkshop-95…
-
# Proposal: use [multi_pin xxx] in config files
Make use of some multi_pin aliases and/or controller_fan definitions to control fans otherwise controlled by different pins.
There's multiple part…
-
This has been mentioned in several other issues but as far as I can tell no solution has been found. Other stepper libraries allow passing in an absolute current limit in milliamps given an Rsense val…
-
how do i connect limit switches with 3 pins that have 5v gnd and signal? and is the stepper disable pin connected to enable on the stepper driver? unfortunately this is not visible on the schematic sk…
-
Does anyone know the PIN allocations on the Ti board that the Phoenix connector links to...
I have a servo to test on the bench and haven't been able to get the PCB daughter card from James yet. I ca…
-
### Description
A number of people have an XYZPrinting Da Vinci printer, and while it has a Repetier fork bouncing around, it's quite old now and the Marlin firmware would be a very nice upgrade.
…
-
Hello folks.
I am trying to get the "MKS TMC2160-OC V1.0" driver working with my Arduino Uno board & a Nema23 stepper.
I connected all wires from the driver SPI (CS, DO, DI and SCK) to the corresp…