-
Vehicle wizard is not detecting incorrect firmware versions on Sparky1. Wizard runs with Tau on the board with no warnings.
-
Existing code (Potentially removed) is aimed at direct servo control, Propose enhanced POITracking control via MAVLink or STorM32 protocol directly to STorM32 brushless gimbal.
Project should re-enab…
-
As per the title. Also a great moment to make a unit test.
-
Here is the concept of oneshot PWM by Felix:
"normaly MWC workes with 488Hz periodic PWM witch mans one PWM cycle takes ~ 2.2ms and the value that need's to be send can just be updated after each cy…
-
Introduced by TauLabs/taulabs#1791 / support for TLM
1. Board hardware revision selected for TLM is used by OPLM.
2. Port configuration broken in various ways.
3. buffer sizes
4. WHo knows what else.
…
mlyle updated
8 years ago
-
Hi, could you make any schematics available? I have a rough idea based on the board.h how it goes together but would be better if I had some basic schematic :) If you would like to PM me (instead of m…
-
Tried two different d4r-ii RXs in PPM mode (signal pin 3 + 4 bridged) that I swapped back and forth between another quad (works fine) and the Brushed Sparky (doesn't work at al). d4r-ii is bound to my…
-
https://github.com/TauLabs/TauLabs/issues/2115
Brief inspection of the code doesn't show a reason why
mlyle updated
8 years ago
-
None of the altitude numbers I get ever make sense. I can init on the ground and take off at -24m.
See also: https://github.com/TauLabs/TauLabs/issues/1596
-
I have been experiencing GCS build failures on windows recently after using 'make all_clean && make all -j', it will work fine with -j4, and in the case of my i7 processor I believe that -j is using 8…