-
Apologies if this is not the correct way to ask a question of the project team. What modifications would be required to allow this to be used with a higher voltage power supply & a larger stepper moto…
-
Hello, I'm trying to connect [tmc2209 v3.1](https://aliexpress.ru/item/33027610442.html?sku_id=67201619468) to UART,
jumper in right place, like in manual
![image](https://user-images.githubuserc…
-
Thanks for library!
I'm trying to setup TMC2208 drivers on all axis on my RAMPS 1.4.
I'm connected all drivers with RX & TX, set correct pins in config, using software serial pins.
Problem is M122 …
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
MKS_UI: Y axis movement loss / offset, does not occur with Marlin color UI
### Bug Timeline…
phcay updated
3 months ago
-
### Is your feature request related to a problem? Please describe.
_No response_
### Are you looking for hardware support?
Does marlin support ESP-S2?
### Describe the feature you want
Hello ever…
-
It appears the Logs directory and the Test directory were updated with assets from the 1.37.58 version; however the "src" directory was not updated. So the source code is missing for the version of t…
-
Hi,
I wanted to set the blank time (TBL) and found in the code (TMCStepper.cpp) the following possible values:
```c
void TMCStepper::blank_time(uint8_t value) {
switch (value) {
case 16…
-
Hi teemuatlut, you did a great job with this library!
I am having a little problem that I can't solve with your documentation (certainly because I am not much of a programmer)
I want to swap old A49…
-
After waiting a long time due to the delay with the shipping of the covid-19, I finally received the item.
Then I installed it on my printer, following all the instructions I received from its github…
-
### Description of the bug
When Arachne engine is on, the produced gcode induces the printer into what looks like high stuttering, when printing the outer perimeter of the inside (3d model attached).…