-
The front of the cowling around the HE fan appears to only be 2 layers thick (0.4)? Seems too thin and wonder if this is an oversight/mistake? In the previous release the front was 4 layers thick (0…
-
Is there a chance you could make the Z motor skirt mounts for a 350 sized Trident? I'm thinking the current set only fit a 250.
-
there seems to be an error on the right side (looking at it mounted from the front) of the bowden cowling.
it is cut in towards the front of the part
![Screenshot 2023-06-12 at 20 20 22](https://git…
-
In ultrawaffles e3 to switchwire conversion, there are a couple of issues with the stls.
The left xz left bearing block in the repo does not match the cad file, and also does not align with the ri…
-
### Description of the bug
I´ve specified extrusion width in percents and it gives error, when i write it back to milimeters the error is gone.
### Project file & How to reproduce
[ps error screen…
-
Page 227, with the astronaut art, says "Electronics" on the top left corner, despite the electronics already having been finished. Following the format of the other art pages, it should be empty in th…
-
Pahe 34 has a random "Top" in the top left corner of the page.
-
In the manual on page 224 the doors is installed first, afterwards on page 225 the magnet holders for the front door are installed (these work great with m3x8). There is a slight inconvenience, if the…
-
The current skirt version for the V0.2 has one open side in every screw hole, which makes the skirt installation a breeze. Just fasten the screw a little bit in the preloaded nuts, align them a lot fa…
-
Hi,
docs/sourcing guide states that Z motor has to be high up to 34mm, which is e.g. OMC 17E13S0404MB-200RS (stated in sourcing guide, including link to it).
But there's only 32.2mm clearance:
![ob…