-
### Category
Other
### Hardware
T-Beam S3
### Firmware Version
2.1.14.fbcd6743
### Description
After solving the display issue (see #2519), which was - to my understanding - due to missing powe…
-
There was an update to the XPowers library in commit :
[Update XPowersLib](https://github.com/Xinyuan-LilyGO/LilyGo-T-SIM7080G/commit/25fb93c3b6bf04fbc0440a493bd91e6b632c1281)
before this update I…
-
Hello Dear,
May be this issue is not related to the library.
But i have no any other support sources.
The new boards arrived. All 50 are having strange behavier.
It is eather electrical connec…
-
Hi,
I found an I2C conflict between PMU and I2C sensor. If I give Wire.begin(sda,scl) for MPU6050 sensor ahead of PMU.begin(Wire, AXP2101_SLAVE_ADDRESS, I2C_SDA, I2C_SCL), it reported PMU failed …
-
The source code seems to work only when a serial monitor is connected. If i disconnect the serial monitor, the stream stops and therefore i cannot connect this to a power plug to stream video. Any wor…
-
## Describe the bug
Valetudo interface is not reachable on local IP address after robot has been disconnected from WiFi access point for about 4-5 minutes. SSH access works and restarting Valetud…
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.0.0.18ab874, 2.0.3.09fe616 Alpha
### Description
I have confirmed this with 4 of my ttgo t-beam v1.1. Low battery shutoff and occas…
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.0.0.b7ef6323-d
### Description
when the device is in light sleep i am unable to wake it by the button.
It seems like it is going…
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.0.4.7022807f-d
### Description
TBeam panics when middle button is pressed long like when adjusting the brightness and the display i…
-
Hello Dear,
Thanks alot for your work.
I think the structure should start with 1 and not with 0 according to the datasheet.
000 is 'reserved'
Kindly check if i am right or wrong.
This the follo…