-
Hi,
I found that BPL v2.5 (BrewPiLess.v2.5.sonoff.bin, BrewPiLess.v2.5.1.sonoff.bin) cannot detect the original temperature sensor connected to Sonoff TH10. It only shows External Sensor (but no va…
-
Greetings. It would be cool to have the following new devices in Wokwi:
- CD4026 (К176ИЕ4) BCD counter with built-in 7-segment decoder
- LM35 analog thermometer
- DS18B20 digital thermometer
Thank…
-
I need micro:bit v2 micropython .py library files for the onewire protocol and DS18B20 driver for a waterproof temp sensor. Research has been frustrating. Has anyone ported this yet.
I took a look …
-
Here is the idf.py build log when trying to compile this example for target ESP32-C3 and using esp-idf master branch:
```
$ idf.py build
Executing action: all (aliases: build)
Running ninja in …
-
Is it possible? Would love to read temperature in pin 4 with a DS18B20.
Also curious if the pyxis-gpio daemon in your repo is required for Pi3+
-
Arduino IDE 2.2.1 all libraries updated to current available.
Attempting to run a DS18B20 Dallas Semiconductor temp sensor on the "I2C" JST connector of a LilyGO T-Display S3.
The reading was -127 w…
-
When use ESP8266 and DS18B20 with **parasite** power pin must be configured as push-pull (DRIVER(NORMAL)) before use. Otherwise power from external pull-up resistor will be not enough to drive DS18B20…
-
-
Hallo zusammen!
Habe einen Sketch erweitert und ihr könnt ihn gerne auf der Homepage verwenden. Es ist der originale HM-WDS40-TH-I-DS18B20 von papa PLUS i2c Display Anbindung, das die Temperatur ze…
-
I am struggling to get the ATtiny816 to respond as a OneWire device to an ESP32 master. Running the DS18B20 example.
Background info:
The bus and master physically work. I have another real DS18B2…