-
I used esptools about 2 weeks ago to flash up to the latest Bin images ( from espressif github). in that I went from V0018 0.9.2 to V 020 0.9.4 all worked fine no issues
I now find I cannot commun…
-
I have some bloody ghosts :-( and yes I read issues of others guys...
I have one P3 64x32
That I done:
I use Wemos D1 R1, butI tried with one NodeMCU too ( like in differents tutorials )
I chang…
-
I'm using this matrix https://www.sparkfun.com/products/14646
I'm wiring directly from the panel to a raspberry 3 B+ with no breakout board
the matrix is powered by a 5V 2A power supply
I'm…
-
Would there be a chance to add an alternative MQTT broker (with same parameters as primary)?
If it did not get to the first one, it would try to the other (as with WiFi SSID1, SSID2).
-
Hi,
I would like to know how to program I/O of ydy40 as input or output.
Also, what is the maximum current i can pull from an output. Can i drive a relay ?
Thank you
-
Hello probably I'm missing something to do...
I flashed a couple of wemos d1 mini with relay and today also an electrodragon (ESP826612f), and all have the same behavior, I cannot access the boot con…
-
Hi !
I'm trying to test your shady but I'm getting errors when compiling:
`
pi@raspberrypi:~ $ go get -u github.com/polyfloyd/shady/cmd/shady
# github.com/polyfloyd/shady/renderer
go/src/githu…
-
Hi I bought 2 of these devices cheap as chips off ebay. V2.3 with no RX/TX pads and no IR connected.
I flashed one of them with the latest tasmota build using esptool (via raspi with serialUSB), mak…
-
Does using the Active3 header for the raspberry pi eliminate the need for the Adafruit one if you don't want to try and hack it for the 64x64 led matrix?
-
I have had a quick look at some 64x64 P2.5 panels and discovered there is an additional decode line 'E' on the HUB75 interface. This is pin 8, which is currently pulled to ground on the Raspberry Pi …