-
Alpha Innotec WZSV 62K3M Version V3.89.5 | Heatpumpt Type : MSW2-6S
The Value temperatureHotWaterTarget is in some cases not right. If i set the temperature over Openhab or the Heatpumpt itself i g…
-
I can make my Panasonic CS-HE9JKE model react on requests made by this fine heatpump library. However, it starts blinking the Timer led for a few min. When timer led turns of the heatpump starts swin…
-
While compiling for the code in ESPHOME. the log gave some warning below.
Warning below:
-------------------------------------------------------------------------------------------------------…
-
This is more a feature request instead of an issue.
When using watts vision in a setup which allows for cooling and heating operation modes, it would be very usefull to identify which mode the sys…
-
Dear BenPru and developers!
I have an Alpha Innotec heatpump and using 2023.9.10 integration. Due to a hardware sensor problem my HP is running a lot on secondary heat source for both heating and hot …
-
### The problem
Esphome appears to have only 3 fan speeds for climate, but some heatpumps via the arduino heatpumpir library have 3, 4 or 5, The mapping is hardcoded.
It appears the heatpumpir lib…
-
Hi at all,
i started to use ebusd with ebusadapter to get data from my hautec heatpump. Installation went realy easy and i could collect data. But now there is my problem. I want to start decoding t…
-
### Log message
```text
Please paste logs here
```
### DPS information
```text
{
"result": {
"model": {
"modelId": "ebsdl0",
"services": [
{
"actions": []…
-
Currently the LGEDevice never shows as unavailable, even when a device is disconnected and offline. If a device is no longer online it would be nice if the sensors showed an unavailable state.
My use…
-
**Why is this needed**:
Currently when using y-axis mapping with discreet values the y-axis will be cluttered with unattainable values.
This will clean up the view and only leave the y-a…