-
**********
ghost updated
3 years ago
-
**URL**: https://skorlive.com/baseball
**Browser / Version**: Firefox iOS 33.0
**Operating System**: iOS 14.4.2
**Tested Another Browser**: Yes Safari
**Problem type**: Video or audio doesn't p…
-
After stopping a print, new print shifts toward X0 about 20mm and Z axes shifts ~0.2mm down. Not sure about y, as it may not be noticeable.
I am not sure how far into the print you need to be or ho…
-
I know marlin has Dual X Carriage support, but would be nice if there was a way to set both extruders to active on a dual setup (two extruders attached to same X Carriage). This way you can print two …
-
Hello there,
Im not sure this is the right place for this, but regardless, Im wondering how and is it possible to incorporate some rudimentary kinematics that aren't "supported" by Marlin natively. …
-
The command G12 P0 and P2 are working fine.
Command G12 P1 T2 S1 doesn't work. No reaction, no moves.
Config with dual extruder:
````
#define NOZZLE_CLEAN_FEATURE
#if ENABLED(NOZZLE_CLEAN_FE…
-
Hi,
I think I've come to the conclusion, based on the title of this post, that the new SKR-2 board needs to use Marlin Binary File Transfer to perform updates from OctoPi because the SD Card cannot…
nezil updated
3 years ago
-
Currently the incoming 5V from USB is not connected to anything. That means when the Mobo is only powered by USB, the MCU can't be operated.
In normal usage, this is not a problem. However with th…
-
Often I have to select the speed percent and change it back to normal (100%). Something is randomly putting in other percentages like 104%, 242%, 123% and so on. I have to be really careful to check …
-
### Bug Description
A) Going to Laser Control setting power (anything other then 255) and enabling Laser, laser output is turned on, and laser fires at correct setting but then turns off by going b…