-
It looks like with the current setup, the inflow velocity magnitude is quite low at high angles of attack. Using the element location seems to do a better job in this respect, despite slightly higher …
-
-
```
Application Version: 5.4.0 Serial
SVN Revision Number: 4198
Compile Date: 16 June 2009
Operating System: Linux
The attached case fills up a tube with ultra-fine water mist droplets.
Looking at t…
-
```
Application Version: 5.4.0 Serial
SVN Revision Number: 4198
Compile Date: 16 June 2009
Operating System: Linux
The attached case fills up a tube with ultra-fine water mist droplets.
Looking at t…
-
```
Please complete the following lines...
Application Version: FDS actual version source part.f90
SVN Revision Number:
Compile Date:
Operating System:
Describe details of the issue below:
The subr…
-
```
Please complete the following lines...
Application Version: FDS actual version source part.f90
SVN Revision Number:
Compile Date:
Operating System:
Describe details of the issue below:
The subr…
-
Lines 197--212 of [`SatfuncPropertyInitializers.hpp`](https://github.com/OPM/opm-parser/blob/master/opm/parser/eclipse/EclipseState/Grid/SatfuncPropertyInitializers.hpp#L197) (method `findVerticalPoin…
-
There seems to be a problem with the combination of automatic and manual mode. After the automatic mode has applied and I switch to manual mode, I can adjust the points. However, once I try to add poi…
-
@ezve and @adimako found that "During simulations with more refined meshes, it was observed that in some cases, a Courant number restriction of 0.33 resulted in very low time-steps that excessively in…
-
Build it. This should allow users to use a (pressure, saturation, saturation, saturation, ...) formulation for multiphase fluid flow instead of a (pressure, pressure, pressure, ...) formulation.