-
hey
sorry my english ist not very good, i come from germany
but i have the problem with the matek board an a GY-91 (10Dof)
MPU9250 (acc,gyro) with integrated AK8963 mag
and a BMP280
i h…
-
NRZ-2017-100-B7 seems to be unstable.
Testing over 2 hours: not more than 10 measurements/cycles are run,
then a reboot is done.
Sensor is not touched within the time and connected by 2A powers…
-
1. No GPS data through smart port Omnibus F4 V3 (pin-out attached as ID'ing these boards is difficult), works with BF3.3.3. I have confirmed by flashing BF3.3.3, got all smart port sensors working, th…
Ant73 updated
6 years ago
-
Hi all. My first post so I hope I'm doing this right.
QAV540G
Naze32 full
Ublox m8n
When in GPS hold, the quad wanders up to about 10 meters. Was showing signs of long slow toilet bowling so I've re …
-
Hi everyone !
I have a issue that I can't find anywere else.
When I use multishot as ESC protocole my Magnetometre get disconfigured " AUTO => HMC5883" when my FC reboot, ant it's the same with th…
-
Hello I have an issue with the RTH of my Nano Talon:
https://www.youtube.com/watch?v=4Vkr9FsFnVo
After a positive maiden flight (exept heavy wingrock) the plane came back home and did everything…
-
### Board and Version
Omnibus F4 Pro V3 (https://www.unmannedtechshop.co.uk/omnibus-f4-pro-flight-controller-v3/)
# INAV/OMNIBUSF4PRO 1.9.0 Mar 5 2018 / 00:15:43 (dc4ef594f)
GPS:
https://www.ba…
-
### If your issue looks like a hardware fault or a configuration problem please don't raise an issue here.
### Please consider using other user support options such as asking the manufacturer of th…
-
I tried the compass calibration for this [GPS Ublox NEO M8N + Compass](http://www.banggood.com/Ublox-NEO-M8N-Flight-Controller-GPS-with-Protective-Shell-for-PIX-PX4-Pixhawk-p-1005394.html) (see link t…
-
Modifying this code to run "down under". The changes to create negative values for lat/long are trivial, and the sun position is then calculated and displayed correctly.
The moon() function seems to …