-
I am used from Octoprint and Repetier Server to being able to browse all saved programs on the printer remotely and start them.
I would like this feature to be integrated, so Its not necessarry to sl…
-
Have you seen this new feature on Marlin?
https://github.com/MarlinFirmware/Marlin/pull/9700
Wondering if it's something Repetier would consider porting over :)
-
Having intermittent hanging of the host/firmware comms since switching to 091 FW. No problems with windows/linux but since moving to 091 fw, pressing the extrude button or jogging multiple times, han…
-
İ connect my PC to MKS Robin 2 3d printer.i arrang eeeprom in repetier host program. After that i make change MKS Robin 2 config. And i install SD card MKS Robin 2. İ push the reset button.. than the…
-
Hi, I'm using TFT70 v1.1 with latest firmware (mkstft70.bin and MksWifi.bin),
The wifi module is an Mks Wifi, already connected, the signal is good.
But connection normally is very unresponsive, a…
-
when i use it for my printrbot it doesn't work.
i press the down buttons, it goes up. when i press the up buttons it does nothing. and i can figure it out, even when it starts the print cura just keep…
-
Everything works fine, untill the second move command (after the skirt) then the printer just freezes.
I Have tried both OPS mode 1 and 2
Firmware 9
Repetier host
-
Hi! I'm working on making a polar printer, and right now the gcode for it is being made manually. The machine is already using Repetier and it's working fine (still needs a lot of tweaking, but it pri…
-
I'm going to build "vertical plotter", and want to make it WiFi way (ESP8266).
Did not found yet project what already did it.
Your firmware with **gcode** looks more usefull and promising then "…
eimix updated
6 years ago
-
Maybe this is just me, but I can't get .56 to even open. I've downloaded a few earlier versions, which similarly refuse to open. When I try to click it, I get an instant crash and an error message a…