-
I am trying to output to a device that uses G-code measured in millimetres (a Sainsmart Genmitsu), but the Inkcut g-code output protocol seems to only use integer outputs, which is insufficiently prec…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Default pin mapping for MKS GEN L V2.1 (EEFB, Extruder Extruder Fan and Bed) doesn't match [P…
-
I swapped out my Endurance laser for my SainSmart (done this many times before) but now when I try to connect I get nothing. Tried connecting to the controller, only response I can get through any pro…
-
### Steps to reproduce
How can we trigger this problem?
Set up a PCF8574 with 4 outputs and 4 inputs. Set up 4 as input switches as 4 tasks. Or 3 as in my setup.
Does the problem presist after …
-
New install to control a mini-fridge for beer fermentation purposes. Have a DHT22 temperature sensor that MyCodo is able to read and keep history. Using Raspberry Pi GPIO pins 23/24 to control a sol…
-
LOVE GRBL Control+. However, lately it has been stopping in the middle of a job. The spindle will still be spinning, but motion has just "stopped." Sometimes it will restart when I press the red-bo…
-
Hello, I tried to search the forums, but they have been down for a few days now.
I installed OpenSprinkler on a Raspberry Pi Zero W, got it all configured successfully. I then wired it up to a SainSm…
-
Hi. I wonder if anyone here knows why, when running sip.py the stations (valves) are immediately energized all at the same time and with out a station program indicating so.
Right now, when I run …
-
Long time no chat, I'm the original author of https://github.com/Fmstrat/diy-ipmi for which I used to have credit on here as this was based off that, but as I'm updating my systems I realize pikvm has…
-
Hi Scott,
When selecting `BOARD_SAINSMART_2IN1`, a compiler error comes up, due to the following issue with `pins.h`:
=== Current ===
``` cpp
#elif MB(BOARD_SAINSMART_2IN1)
#include "pins_SAINSMA…