-
This pertains just to the houston-sstv package rn but, maybe if I try and use similar code later I could get an issue?
Obviously what I see on my end (inside the docker container)
```
root@1f9b51…
-
I have been having issues compiling on a raspberry pi 4 and I noticed that line 52 of CMakeLists.txt has a comment describing the SSTV decoder as the M17 decoder. Compilation has been failing at this …
-
**Describe the bug**
SSTV examples not working with ESP32-S and RFM98 at 434 Mhz . Tried varying the correction factor and changing modes (Wrasse, Martin1). Only a narrow (1khz) continuous carrier i…
-
When a Kerbal attempts to pick up the part in question after it was deployed, it would remain in place in a non-functional state, while creating a duplicate in the Kerbal's inventory. The non-function…
-
**Is your feature request related to a problem? Please describe.**
When using slow CPU speeds (to save Solar / Battery power) the timing of (micros() - start < _bitDuration) gets too far out and caus…
-
Hi, thank you for the great software!!
I am running the following command
python -m pysstv --mode PD180 --vox /media/pi/2655-2656/STS-1/sstv_image.jpg --keep-aspect-ratio --rate 44100 sstv_image…
-
**Describe the bug**
Trying to transmit a Morse message in the Morse TX application with "CW" modulation. The transmitted signal is simply a single tone/carrier, there is no modulation. In FM mode ev…
-
Hi!
This looks like a super useful addition to a remote HF site I am involved with, which has (along with multiple KiwiSDRs - see kiwisdr.areg.org.au:8073 ) a pile of Airspy HF+ Spyservers - one fo…
-
I was able to compile fine, but when I run:
sudo PORT=/dev/ttyUSB0 make flash
It looks like it's trying to flash the Evil Crow. Lights on it are blinking. Then, I get this: Any ideas what I'm do…
-
Hi,
I would like to use your software to integrate a Bresser 9602510 (5in1) sensor via MQTT into my system.
I can't get it to work. I already stopped after "Starting execution..."
I followed your…