-
Hi!
i'm having issues compiling... do you have a newer version?
SKR DIP e3 with 4x2208 on a Ender 5
Thanks in advance
-
Hello world, my first post @ git :) I have read similar topic which is closed, there was no solution for problem.
I switch from ramps to skr 1.4 turbo (Marlin 2.9.0.1), got 2x tmc2099 for X,Y but i w…
-
Hello,
I was looking under the pin group and I didn't see a pin specific for "auto power off after print", I am assuming that PS_ON_PIN?
I am using an inductive z probe and I wanted to know the m…
-
Apologies if this is not the correct way to ask a question of the project team. What modifications would be required to allow this to be used with a higher voltage power supply & a larger stepper moto…
-
Thanks for library!
I'm trying to setup TMC2208 drivers on all axis on my RAMPS 1.4.
I'm connected all drivers with RX & TX, set correct pins in config, using software serial pins.
Problem is M122 …
-
Hello ZoetropeLabs,
I tried using this library with my as5048a, and normally if anything doesn't work properly I would assume it was my mistake at some point. However, I tried the same connection w…
-
#### What were you doing?
I was printing long print overnight. It contained long lines that were triggering timeout warning.
Later, to have better sleep, I slowed the printer down using feed rate …
-
Hi all
First one... sorry for bad english:)
My printer is made from
SKR 1.3
XYZ - TMC2208 UART
E - A4988
BLTOUCH
TFT24 v1.1
Marlin Version 2.0.5.3
I have got some issues with configurat…
-
After waiting a long time due to the delay with the shipping of the covid-19, I finally received the item.
Then I installed it on my printer, following all the instructions I received from its github…
-
It appears the Logs directory and the Test directory were updated with assets from the 1.37.58 version; however the "src" directory was not updated. So the source code is missing for the version of t…