-
M122 - I'm running a TMC2208 on X and a TMC2130 on E0. I can figure out some of the readings but am not sure on what all of the abbreviations mean. I have looked all over for a guide but everythin…
-
Beaglebone black + Replicape Rev B board is not supported by Marlin. Would really be nice considering the hardware capabilities it can provide.
-
I apologize if this isn't the correct place to ask this - new to github
Would one be able to use a thermocouple through the adafruit board wired this same way?
Does PT100- analog = a thermocoupl…
-
I'm attempting to use BigTreeTech's TMC5160 breakout board via SPI for controlling a 2.0A NEMA bi-polar stepper, in the interest of integrating the Trinamic StallGuard capability into my project. The …
-
Hi,
Tried to find any contact info to send you a private message, but couldn't find any thus I'm writing this post.
Have you managed to test current layout of the board? I'm in need of such contr…
-
Hi Terjeio, I bought a SKR3 and it arrived with STM32H723FZG6. There is the driver for H743 here and I will use it. My doubt is... will it work? Any tips, help will be welcome. Questions... 1. If it …
-
Hi, i using a board stm32f407vet6 and compiled version of the grblhal activating ethernet, that works correctly when connect first the usb cable and iosender for check boot.
But when not connect th…
-
Hello,
I recently modified the Simple.ino example so that I could get my motor to step enough times to make one full revolution (200 in my case). However, I am having issues where I have to increment…
-
Hi there,
I am using the TMC5160 with a custom setup for driving actuators, I used them quite for a while with different setups and length and everything always worked out well. For a new project i a…
-
Given that this unit is able to detect missed steps could this functionality be adapted to allow for sensorless homing ?