-
New android (N+) has an option specifically for this. It's called the "sustained performance mode". It is designed to allow apps to opt into a mode that *disables* any unsustainable boost clocks. This…
-
I understand that my Sonoff RF Bridge with Tasmota 5.14.0 is not able to decode RF Codes other than 24bit length? I got a very old set of RF power plugs (Company REV) which works fine. I got just now …
-
1.《智能汽车安全攻防大揭秘》[https://www.amazon.cn/dp/B075QZXY7W](https://www.amazon.cn/dp/B075QZXY7W)
2. [Inside Radio: An Attack and Defense Guide](https://unicorn.360.com/blog/2018/01/29/Inside_Radio_An_At…
-
Hi,
Firstly thank you for your great efforts.
Secondly, does your code support the RF features of the RM Pro devices?
-
Not receiving with the lib on Raspberry Pi.
Since two RPis are one foot apart, only left antenna on receiver. I verified using correct GDO2 pin with an LED, G25.
sudo ./RX_Demo -v -a3 -c1 -f434 -…
-
## Hardware
Go
## Steps to Reproduce
1. Uninstall FxR
2. Install from Oculus app store
3. Press Start Button
## Current Behavior
FxR runs for a few seconds and then disappears.
…
-
In Australia and some other countries, we also use devices that utilise the 315mhz frequency. Could this library be extended to support them also?
-
Mark,
This is not an issue, but just a placeholder to share with everyone my usage of your library to control 315Mhz Radio transmitters rather than LED's, and ultimately control my Fireplace. I wa…
-
is it possible？
-
First of all I have to say, what you did is quite impressive... I have few broadlink devices and the only way I was able to control them eventually is via UDP packets.
To do that, I had to learn the …