-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
The G29 command for bed leveling won't work in release 2.1.2.2, 2.1.2.3 and 2.1.2.4.
My setu…
-
Hi there i am new to all this programming stuff i have a mks sgen v1 with tmc2209 on x, y, z, e1, axis and lv8729 on e0 i am trying to get sensor less homeing to work and dual z motors z, e1
i am…
-
Hi, Using 4.3.9 Configured with the online configurator. Have 2 nozzles set up by adding the following to configuration_overall.h
#define SWITCHING_NOZZLE
#if ENABLED(SWITCHING_NOZZLE)
#de…
-
### Description
Autoleveling bed fails after first touch point. No errors on LCD.
### Steps to reproduce
1. Try to autolevel from printer
**Expected behavior**
Autolevel hits 25 points…
-
I apologize if this isn't the correct place to ask this - new to github
Would one be able to use a thermocouple through the adafruit board wired this same way?
Does PT100- analog = a thermocoupl…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
On an IDEX set up, after switching active extruder from T0 to T1, T0 parks to the endstop, bu…
-
### Description
The stock start gcode for the Taz 6 includes the G26 to "clear potential 'probe fail' condition". It appears Marlin now uses it to validate the bed leveling mesh.
### Steps to…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
When I start printing everything is fine for the first couple of layers. Then the print…
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Hello, I read through a post and then downloaded your firmware. I then entered the command C104 …
-
I've recently added a BLTouch to my CR-10S Pro (v1) and installed the latest stable 2.0 firmware using the `10SPro_BLT_BIL_DW7.4` hex file from the `CrealityDwin_2.0` branch. After a few days of usin…