-
SKR mini E3 v2.0 wont compile and throws these errors before failing in latest version of VSCode with PlatformIO
In file included from .pio\libdeps\STM32F103RC_btt_512K\Adafruit BusIO_ID6214\Adafr…
-
I recently flashed my cb1 with the following image: CB1_Debian11_minimal_kernel5.16_20230303.img.xz
after installing klipper / Mainsail I cannot access my SKR mini e3 v3 due to lack of serial/by-id…
-
Goodmorning
i have an skr 1.4 pro mounted in my CR20pro . I have attached an BTT TFT7.0 screen all new. I am getting only a white screen.
It looks like i don't get a signal from the board. I tested…
-
Issue 1:
These files can be found in 2 locations on GitHub, and the BOM consequently lists them twice even though only one copy is required:
[a]_BTT_MMB_Box_Lid.stl
[a]_BTT_MMB_support_arm_bottom.s…
-
Can at least "commend" it that it broke in the closed position. Otherwise i had to redo the firmware, or buy a new board right now.
Used it for about 5 months. WIthout any heavy use. Worked fine.
…
-
Hi,
Klipper is probably 3D printing's most advanced firmware.
It is a two part system where the hard math is done on a real computer, and the real time stuff is done on a microcontroller.
A s…
-
Hey there!
First off, thanks for putting this out there @fryc88! Long story short, I was going to Klipperize my Sovol SV01 Pro, but hit an issue on the last print that I did before that. The part…
-
Hello everyone.
I have a strange problem. For not knowing reasons one of my two hot end's stop working. But I will start from the beginning.
Few days ago I just finished upgrading my old Wanhao …
-
I finally was able to get an SKR 1.4T & Exp-Mot working together.
My Config is a CoreXY with 4 Z Motors and The New BugFix 2.X Marlin.
Marlin 2.0.7.2 does not work with the exp-mot, unless you want …
-
{"format":"img","model":"DS920+","version":"7.2.2-72806-0","addons":"acpid,cpuinfo,powersched"}