-
**Please, follow this template when opening a new issue: this will help us a lot in the process of helping you.**
### Issue description
Tell us here what happened: don't miss any valuable detail, …
-
During a g0 seek in M3 laser mode, the spindle (laser) can be turned on if subsequent g1 commands are fed to the planner.
This seems to be a consequence of line 195 in motion_control.c.
At this poin…
m-g-m updated
2 years ago
-
This is related to LibLaserCut (for the actual implementation), but since this is a general issue about additional buttons, I thought I'd open the issue here.
The OMTech Polar is a capable device, …
-
Hi patyork,
I downloaded your source code and hope to try out your modified firmware settings for laser cutting and avoiding pauses on tinyG due to S command changes.
Of course I could load up t…
-
# Describe the bug
Heat, electric, and biological damage start to appear in mods but aren't handled well.
Mobs only can have armor specified for the following damage types:
armor_bash, mon.arm…
-
@ranranking could it be that the laser cutting files for the Fourier Mask are missing?
-
Hi,
First off: Please be aware that your little piece of software is THE HOLY GRALE for many many people that work with dxf files and it needs more traction and get more publicity or it needs to be…
-
The compressor used for [air-assist](https://www.instructables.com/DIY-Cheap-and-Quiet-Air-Assist-for-Laser-Cutting/) is inside the unit; it looks like [this](https://laboratoryb.github.io/camfive/doc…
-
My CO2 Laser Power Supply have these connections:
H: Laser output control (high level effective)
L: Laser output control (low level effective)
P: Water protectio switch (valid if grouded)
G: Gro…
-
### Feedback
Your concept and explorations have been pretty solid. The idea of mapping the same area overtime is very strong and will be impactful as a series of separate maps or one layered map. Exp…