-
```
Connecting MinimOSD with Firmware v2.2 to an APM running Arducopter on a
hexacopter or octocopter will not update the flight mode osd. That's because
line 877 of OSD_Panel.ino (rev 563) is:
> …
-
```
What steps will reproduce the problem?
1. herein after two configuration files to see the difference. My home altitude
is 120 m
2.
3.
What is the expected output? What do you see instead?
in the…
-
```
What steps will reproduce the problem?
1. herein after two configuration files to see the difference. My home altitude
is 120 m
2.
3.
What is the expected output? What do you see instead?
in the…
-
```
What steps will reproduce the problem?
1. herein after two configuration files to see the difference. My home altitude
is 120 m
2.
3.
What is the expected output? What do you see instead?
in the…
-
```
What steps will reproduce the problem?
1. herein after two configuration files to see the difference. My home altitude
is 120 m
2.
3.
What is the expected output? What do you see instead?
in the…
-
```
What steps will reproduce the problem?
1. herein after two configuration files to see the difference. My home altitude
is 120 m
2.
3.
What is the expected output? What do you see instead?
in the…
-
This causes QGC to not be able to load heli firmwares on all boards. I'm not sure if it is just "OFFICIAL" versions which are incorrect. But those are the only entries which QGC uses for now.
Here …
-
```
Connecting MinimOSD with Firmware v2.2 to an APM running Arducopter on a
hexacopter or octocopter will not update the flight mode osd. That's because
line 877 of OSD_Panel.ino (rev 563) is:
> …
-
```
Connecting MinimOSD with Firmware v2.2 to an APM running Arducopter on a
hexacopter or octocopter will not update the flight mode osd. That's because
line 877 of OSD_Panel.ino (rev 563) is:
> …
-
```
Connecting MinimOSD with Firmware v2.2 to an APM running Arducopter on a
hexacopter or octocopter will not update the flight mode osd. That's because
line 877 of OSD_Panel.ino (rev 563) is:
> …