-
First off, this is by far one of the best documented libraries I've come across, so thank you very much!
I wondering if you have any more examples illustrating how to configure the ublox neo chips? F…
-
I ‘m not sure if this is an iNav issue/bug, but I recently switched from the Omnibus F4 board to a SP Racing F4 EVO because the EVO has more UARTs. The Omnibus hovered stable in with GPS modes on ever…
-
Hi, I'm learning my way with the BBBlue and Ardupilot...slowly. Thank you so much for the terrific installation guide. It's great. I'm just having trouble at the end as per the attached screen sho…
-
Hi everyone,
My quad was working very well with inav 1.7.2 : rth, poshold, waypoint. During winter I let him away due to bad weather.
Since I get it back I have some problem with Gps Mode : Pos…
ValCx updated
6 years ago
-
I've encountered an issue where after upgrading betaflight where my GPS unit was no longer detected when the quad powered up. Flight controller is an omnibus F4 V5 and Gps unit is [HGLRC Neo-M8N M8M U…
ghost updated
6 years ago
-
GPS Rescue has no documentation in the wiki - e.g. how to configure, setup, test, how does it work etc
-
I have issues with external mag under iNAV Config 1.7.3. I have an Omnibus F3 AIO (no magnetometer) FC from RTF Quads. I cannot get it to work with the external compass on my GPS in iNAV. The compass …
-
I have a M8N GPS with onboard compass A983. I've tried all the existing options in the configurator but it remains undetected (I have another 6M GPS with onboard compass L883 and that works) this usin…
-
inav 1.9.0 RC2
Omnibus F7V2
The magnetometer IST8310 is not found on the I2C (RX3 and TX3)
GPS is found
Please check also on Omnibus F4V5
IST8310 works fine now on Omnibus F4V3
-
I flash the latest 1.3 RC2 , because the earlier have a problem to detect the magnetometer (BMP280) on my naze. i think this issue may be corrected. but now
after 1 minute (aprox) the i2c error increa…