-
I ordered a few boards from OSHPark and put them together, but I'm not getting sync on hello_DVI, even with a 1.3V overvolt. I don't have an oscilloscope; is there a good way to troubleshoot assembly?…
-
I'm trying to follow [this](https://playground.arduino.cc/Main/MPU-6050#short) to set up the sensor for my controller but I can't seem to figure it out. The code is uploaded to my Arduino and the valu…
-
Thank you for Open-Frame1, it seems very exciting. I think the PCB ordering process is confusing for new users, so some additional info here would be a big help. The build guide video in the readme do…
-
Hi everyone,
hoping you can help out. I am running a raspberry pi 0 W on buster lite. I have tried quite a few things but the behaviour seems the same. Unfortunately I don't have anything else that…
-
Hello. This one's on me as I'm pretty sure this is just due to my buying an M0 RFM96 feather rather than the advised M4 express feather.
I can make all of the sensors work except for the PM5003, wh…
-
**Support for Sequre S60**
im not sure if it is possible or not to support IronOS on the Sequre S60.
I recently added this soldering pencil to my bench as a companion to a TS80.
The S60 is sh…
-
BOM:
- 1x DMG-KGDU-10+, from JLCPCB
- 1x FM18W08SG
- 1x MX23C1603-12A (DMG-AAXE-0), from original Silver cartridge
- 1x MBC3-B, from original Silver cartridge
- 1x M030 134A, from ori…
-
Thanks for sharing the PCB, I'm about to order from JLCPCB. Just a question in advance, I have only little experience with SMD soldering and wonder if I need the resistors and transistors. It is plann…
-
## Community Repair Café | Team Checklists
This is a collection of checkpoints to help you for a successful community repair cafe
**Do not forget to keep the "Café" Scenario in mind, have fun, co…
-
It would be nice for battery operation if the supply voltage could optionally be shown on the display.
Ideally there would also be an adjustable low voltage warning or shutdown via the menu.