-
My BLTouch works perfectly and deploys and retracts on command but during g28 it will not deploy
/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinF…
-
Compiled with Arduino IDE 1.8.12
Errors shown
losing tmc_util.cpp & endstop.cpp
I have modified the pins_MEGATRONICS_3.h to add on X,Y,Z/Z2,E0 CS pins.
Added filament runout pin & modified temp_1…
-
I followed directions for opening and uploading v2.0, but Arduino IDE gives me the error below. When I open the .ino in Arduino I only see 6 tabs, not the usual numerous quantity of tabs. Do all of …
-
Yesterday I attempted to setup RRF to compile. I downloaded the recommended programs. Downloaded the dev branches of each of the projects and attempted to compile. recieved the following error about G…
-
Hello to all,
I can not compile Marlin 2 for BIGTREETECH-SKR-PRO-V1.1:
In file included from Marlin\src\module/stepper.h:221:0,
from Marlin\src\Marlin.cpp:37:
Marlin\src\module/stepper_indirect…
-
### Description
Not sure if this is an issue with the SPI or the TMC library so close if its out of place. I am having issues with all the TMC2660 drivers in marlin.
M122 Below -------
```
…
-
Today i finded this terrible bug, that makes my machine inoperative.
For some strange reason, if you add to the firmware the config options of a delta, and enable big things that costs a lot of memor…
neox3 updated
4 years ago
-
Do you have any plans to make a step stick format of the board?
of course only a single chip can fit on the board
just a thought, been using google to see if it has been done and your board is w…
-
Good morning!another question/new board for marlin...
After a search on Google I cross upon this board that in my vision has identical footprint as a MKS GEN L board only new is that have an LPC 1768…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…