-
To be brief, I was wondering how Moppy could be extended to be used directly with stepper motors. I am currently using 4 NEMA-17 Stepper Motors with an Arduino and 2 Adafruit Motor Shields. Has anyone…
ghost updated
7 years ago
-
Still very excited.
I think I'm not far from actually printing something. All the motors work, however they are not precise. When I play with the numbers in the config such like `STEPPER_PULSES_PER_M…
-
This is a hard part. Reading up on this is really fun though and it makes very obvious why RC cars really eat up the battery!
This page is a good starter:
https://learn.sparkfun.com/tutorials/how-t…
-
Setting an output by modifying ActuatorSettings is effective but
fairly hacky. It is also somewhat unsafe since you just take control.
My suggestion for PWM Output would to add a type "PicoC" in the
…
-
### PROBLEM DESCRIPTION
We use ESP-12F flashed with tasmota + a4988 stepper motor driver, and found follow issue: when we switch on on `ENABLE` pin(on esp12f this is GPIO5 in out case) of a4988 w…
-
Just power off both heater and bed :(((
Two different (mirrored) pcs at the same heigh.
Hardware: DUE+RAMPS-FD+LV8729 (XY) 8825 (Z+E)
Repetier, Marlin 2.0 works well
`/**
* MK4duo Firm…
-
Hi,
I working on a project using the OpenBuilds C-Beam linear actuator with a NEMA 23 driven by a BigTree TMC2130 V3.0 Stepper and controlled by an Arduino MEGA2560.
SPI communication works we…
-
Hi Cocktailyogi,
do you think that it's possible to use an l293d motor shield for this project?
I think that this shield is perfect: 2 stepper, servo ports and it's incredibily cheap on ebay...
Thank…
-
I just got a Makeblock XY plotter v2.0. It's pretty nice but the software and firmware both kinda suck.
I found grbl and it looks great. I already got grbl running on my device (I can interact over s…
-
Use this issue to submit projects for https://wokwi.com/rust. You can also request to update/replace an existing project, or to remove a project.